Brake fluid should always be flushed and replaced when it reaches the “HOT” or “ODD” warning light on your dashboard. However, knowing where to go for a brake flush can be a bit confusing, so in this article we’ll outline the best places to get your brakes serviced in the Greater Toronto Area.
What Is a Brake Flush?
A brake flush is a service that is usually performed on vehicles that have manual or automatic transmissions. The brake fluid is flushed out and replaced with new fluid to ensure that the brakes are working properly.
Brake flushes can be performed at any car dealership, but they are often more expensive at specialty shops. If you need a brake flush, it’s best to check your owner’s manual or contact your vehicle’s manufacturer for specific instructions.
How to Do a Brake Flush
If you’re like most drivers, you probably don’t think about your brakes very often. But, if something goes wrong with them, a brake flush is the perfect solution. Here’s how to do a brake flush:
1. Park your car in a safe place with plenty of room to move around it.
2. Turn off all the engine lights and accessories (except for your parking lights).
3. Open the hood of your car and locate the brake fluid reservoir. It will likely be on the left side next to the engine. If it’s not there, look for it near the gearshift or behind the car. You may also have to remove one or more panels to get to it.
4. Use a funnel to pour enough brake fluid into the reservoir until it reaches the bottom. Don’t overfill it! Brake fluid is flammable, so be careful not to set off any sparks while you’re filling it up.
5. Close the hood of your car and turn on all engine accessories again. Drive your car around for a few minutes to make sure everything’s working properly. If not, fix whatever’s wrong and come back here to do a brake
What to Expect During a Brake Flush
If you’re like most drivers, your brakes may need a brake flush at some point. Here’s what to expect during a brake flush:
-Your mechanic will first inspect your brake system and make sure it’s in good condition.
-They’ll use a special fluid to clean all the parts of your brake system.
-Once everything is clean, they’ll apply the new brake fluid.
-Your mechanic will then test your brakes to make sure they’re working properly.